GMap 1.x / Location 3.x Tester Checklist

• Enable modules
• Visit admin/settings/gmap and configure API key.
• Visit admin/settings/filters and set up a GMap filter.
• Visit admin/content/types and (create if desired and) location-enable a content type.
• Visit admin/settings/location/geocoding and configure geocoding for a country.
• Visit admin/user/settings and configure the Location Fields section.
• Visit admin/build/block and enable the Author Map and Location Map blocks.
• Visit admin/build/block/configure/gmap_location/1 and enable the Author block for the content type you location-enabled.

• Visit map/macro, play with the controls and ensure map responds, play with map and ensure controls respond.
• Doodle on the map, make sure drawing controls work as expected.
• Copy macro, open another window/tab.
• Create a node, set filter to GMap filter and paste macro.
• Save node, compare display of map to macro in other window/tab.

• Edit your user account. Add your location.
• Ensure geocoding works.
• Ensure the data is not lost when going back to edit.

• Create a node with locative information.
• Ensure Author Map and Location Map display as expected.

Advanced section - Stuff involving special setup or advanced knowledge

• Create test site on Location 2.7.
• Perform tasks from "Setup from scratch" section.
• Create or import test data.
• Install Location 3.
• Attempt to perform updates.
• Ensure in database that data was properly split off into {location_instance}.
• Ensure site settings are in a sane state (You should not get any misconfiguration-related warnings/errors.)
• Visually inspect some locations on site.

• Disable gmap and create locative nodes. Ensure form continues to work in the absence of gmap.